Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 588)

564 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Local VLL
4
Legend for Table 94
X = original outer VLAN CoS
Y = original inner VLAN CoS
X’ = mapped CoS from internal priority (X contributes to internal priority) using CoS encode
table
Configuring Local VLL
Configuring Local VLL uses the following procedures:
• “Local VLL configuration”
• “Specifying Local VLL endpoints”
• “Configuring Local VLL QoS (optional)”
Local VLL configuration
Local VLL is configured under router mpls as shown.
Brocade(config)# router mpls
Brocade(config-mpls)# vll-local test1
Syntax: [no] vll-local vll-name
Specifying Local VLL endpoints
Local VLL can be configured between any combination of untagged, single-tagged, and dual-tagged
endpoints.
The following sections describe how to configure VLL Endpoints:
Configuring an untagged endpoint
To configure untagged port 1/1 into Local VLL instance “test1” use the following commands.
Brocade(config)# router mpls
Brocade(config-mpls)# vll-local test1
Brocade(config-mpls-vll-test1)# untagged ethernet 1/1
Syntax: [no] untagged ethernet slot/port
Untagged to
dual-tagged N/A N/A X’ or 0 0
Dual-tagged to
single-tagged X Y X’ or Y N/A
TABLE 94 Expected class of service behavior for Local VLL
Local VLL endpoints Incoming packet Outgoing packet
Outer VLAN Inner VLAN Outer VLAN Inner VLAN