Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 437)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 413
53-1003031-02
Displaying LDP information
2
To display more detailed information about the LDP peers, enter the following command.
Brocade# show mpls ldp peer detail
Peer LDP ID: 10.2.2.2:0, Local LDP ID: 10.1.1.1:0, State: Operational
Session Status UP, Entity Idx: 4, Targeted: No, Target Adj Added: Yes
Num VLL: 2, Num VPLS: 0
Rcvd VC-FECs:
From 10.2.2.2: Label: 800001, VC Id: 120, Grp_Id: 0, VC Type: 4 MTU: 5000
Peer LDP ID: 10.8.8.8:0, Local LDP ID: 10.1.1.1:0, State: Operational
Session Status UP, Entity Idx: 2, Targeted: Yes, Target Adj Added: Yes
Num VLL: 2, Num VPLS: 0
Rcvd VC-FECs:
From 10.8.8.8: Label: 16, VC Id: 19, Grp_Id: 0, VC Type: 32773, MTU: 5000
From 10.8.8.8: Label: 18, VC Id: 18, Grp_Id: 0, VC Type: 32772, MTU 5555
For each LDP peer, the command displays the following information:
TABLE 57 Output from the show mpls ldp peer detail command
This field... Displays...
Peer LDP ID The LDP identifier of the peer LSR. The first four octets identify the peer LSR IP
address; the second two octets identify a label space on the LSR. For LSRs
that use per-platform label spaces, the second two octets are always zero.
Local LDP ID This LSRs LDP identifier.
State The LDP session state, as defined in RFC 3036. This can be “Nonexistent”,
“Initialized”, “OpenRec”, “OpenSent”, or “Operational”.
Session Status Whether the session is operationally UP or Down.
Entity Idx This displays the LDP session entity CB index maintained by the LDP session
controller.
Targeted Whether the session was established using Targeted Hello messages (that is,
through extended discovery).
Target Adj Added Whether the targeted adjacency was initiated for this LDP peer.
Num VLL Number of VLL instances using the LDP peer.
Num VPLS Number of VPLS instances using the LDP peer.
Rcvd VC FECs Displays the contents of received VC FECs
From Peer LSR ID where the VC FEC was received from.
Label The MPLS label associated with the VC FEC.
VC ID The VC ID associated with the VC FEC.
Grp_ID The Group ID associated with the VC FEC.
VC Type The VC Type associated with the VC FEC.
MTU The MTU value received in a VC Label Matching message from a peer.
Num-VLL Number of VLL instances using this LDP peer.
Num-VPLS-Peer Number of VPLS instances using this LDP peer.
TABLE 56 Output from the show mpls ldp peer command (Continued)
This field... Displays...