Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 667)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 643
53-1003031-02
Displaying BGP or MPLS VPNv4 information
6
Displaying VPNv4 attribute entries information
The route-attribute entries table lists the sets of BGP VPNv4 attributes stored in the device
memory. Each set of attributes is unique and can be associated with one or more routes. In fact,
the device typically has fewer route attribute entries than routes. To display the route-attribute
entries table at any level of the CLI.
Brocade# show ip bgp vpn attribute-entries
Total number of BGP Attribute Entries: 55
1 Next Hop :0.0.0.0 Metric :0 Origin:IGP
Originator:0.0.0.0 Cluster List:None
Aggregator:AS Number :0 Router-ID:0.0.0.0 Atomic:None
Local Pref:100 Communities:Internet
Extended Community: RT 600:1
AS Path :310
Address: 0x24644060 Hash:45 (0x0100036e) Reference Counts: 0:0:30
2 Next Hop :0.0.0.0 Metric :0 Origin:IGP
Originator:0.0.0.0 Cluster List:None
Aggregator:AS Number :0 Router-ID:0.0.0.0 Atomic:None
Local Pref:100 Communities:Internet
Extended Community: RT 600:1
AS Path :311
Address: 0x24645f48 Hash:47 (0x01000370) Reference Counts: 0:0:30
3 Next Hop :2.2.2.2 Metric :0 Origin:IGP
Originator:0.0.0.0 Cluster List:None
Aggregator:AS Number :0 Router-ID:0.0.0.0 Atomic:None
Local Pref:100 Communities:Internet
Extended Community: RT 100:1 RT 200:1
AS Path :206 311
Address: 0x24645538 Hash:276 (0x0100087a) Reference Counts: 30:0:0
This display shows the following information.
TABLE 111 BGP VPNv4 attribute entries
This field... Displays...
Total number of BGP Attribute Entries The number of routes contained in the BGP4 route table for this device.
Next Hop The IP address of the next hop device for routes that have this set of
attributes.
Metric The cost of the routes that have this set of attributes.
Origin The source of the route information. The origin can be one of the
following:
•
EGP – The routes with this set of attributes came to BGP through
EGP.
•
IGP – The routes with this set of attributes came to BGP through
IGP.
•
INCOMPLETE – The routes came from an origin other than one of
the above. For example, they may have been redistributed from
OSPF or RIP.
When BGP4 compares multiple routes to a destination to select the
best route, IGP is preferred over EGP and both are preferred over
INCOMPLETE.
Originator The originator of the route in a route reflector environment.