Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 205)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 181
53-1003031-02
Dynamic Bypass LSPs
1
Name prefix: dbyp, primary path: none Max bypass per merge point: 111, total
bypasses: 0
Total number of merge points 0
Dynamic bypass interface: e3/3, Active status: Enabled
Admin type: Local, admin status: UP
Hop limit: 255, Tie-breaking: random, cos: 0
Setup priority: 7, hold priority: 0
Max rate: 1000 kbps, mean rate: 1000 kbps, max burst: 1000000 bytes
From: 10.11.11.11, reoptimize timer: 0 secs
Adaptive: Yes, record route: enabled
Name prefix: dbyp, primary path: none
Max bypass per merge point: 111, total bypasses: 2
Total number of merge points 2
Merge Point Bypass count
10.22.22.22 1
10.33.33.33 1
Dynamic bypass interface: e4/8, Active status: Enabled
Admin type: Global, admin status: UP
Hop limit: 255, Tie-breaking: random, cos: 0
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
From: 10.11.11.11, reoptimize timer: 0 secs
Adaptive: Yes, record route: enabled
Name prefix: dbyp, primary path: none
Max bypass per merge point: 111, total bypasses: 0
Total number of merge points 0
Syntax: show mpls dynamic-bypass [interface|interface detail |interface ethernet ] lsp_name
Use the lsp_name parameter to select the name of the LSP to display.
Displaying the number of bypass LSPs
The show mpls summary command output has an additional information on the total number of
bypass LSPs in the system. This total number is the sum of the configured static and dynamic
bypasses in the system.
Brocade# show mpls summary
Path:
Paths configured = 6
RSVP-Signaled LSPs:
LSPs configured = 8
LSPs enabled = 8
LSPs operational = 8
Detour LSPs UP = 0
Backup LSPs UP = 2
Bypass LSPs = 2
Bypass LSPs UP = 2
LDP-Signaled LSPs:
LSPs operational = 0
VPLSs:
VPLSs configured = 2
VPLS peers = 2
Peers operational = 2