Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 516)

492 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Clearing VPLS extended counters
3
Table 74 describes the output parameters of the show mpls statistics vpls extended-counters
command.
TABLE 74 Output of the show mpls statistics vpls extended-counters command
Field Description
VPLS Name The configured name for a VPLS instance.
VPLS Id The ID of the VPLS instance.
VPLS Vlan The ID of the configured VLAN.
Interface The port ID of the interface for which the user wants to display the counters.
RxPkts The number of packets received at the specified port.
TxPkts The number of packets transmitted from the specified port.
RxBytes The number of bytes received at the specified port.
TxBytes The number of bytes transmitted from the specified port.
Clearing VPLS extended counters
To clear all the port VLAN counters for a particular VPLS instance, enter the following command.
The command does not clear the existing Endpt-Out-Pkts and Tnl-Out-Pkts statistics.
Brocade# clear mpls statistics vpls 10 extended-counters
To clear all the port VLAN counters for a particular VPLS instance and port under a specific VPLS
VLAN, enter the following command. This command is supported only for a single VLAN instance
and is not supported for the dual tag endpoints.
Brocade# clear mpls statistics vpls 10 extended-counters vlan 10
To clear all the port VLAN counters for all the endpoints of a particular VPLS instance, enter the
following command. When the VPLS endpoint is a Link Aggregation Group (LAG), then the counters
only for the given physical port are cleared.
Brocade# clear mpls statistics vpls 10 extended-counters vlan 10 ethernet 3/2
To clear all the port VLAN counters for the given priority of a particular VPLS endpoint, enter the
following command.
Brocade# clear mpls statistics vpls 10 extended-counters vlan 10 ethernet 3/2 p1
Syntax: clear mpls statistics vpls [vpls-name | vpls-id [extended-counters [[vlan vlan-id] [ethernet
port-id [priority pri]]]]]
The vpls-name parameter specifies the configured VPLS name for which the user wants to clear the
counters.
The vpls-id parameter specifies the ID of a VPLS instance for which the user wants to clear the
counters.