Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 360)

336 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
show mpls ldp tunnel
2
show mpls ldp tunnel
The output of the show mpls ldp tunnel command is updated to include all the paths in the LDP
tunnel.The show mpls ldp tunnel command has a filter for the tunnel destination prefix, ‘brief’ and
‘detail’. The tunnel destination prefix can be either IPv4 host address or IPv4 prefix with subnet
mask. Output of the command with the path destination prefix filter displays a single tunnel entry
for a specified tunnel destination IP prefix. The format of the command output for a tunnel
destination filtered command is in detailed format.
Syntax show mpls ldp tunnel [A.B.C.D|brief|detail|out-interface]
Parameters A.B.C.D
The A.B.C.D option is the tunnel destination prefix.
brief
The brief option displays brief information.
detail
The detail option display detail information.
out-interface
The out-interface option displays the LDP tunnel going out of an interface.
Command
modes
Global configuration mode.
Usage guidelines Displays information about LDP-created LSPs for which this device is the ingress LER.
The brief version shows the list of outbound ports separated by spaces.
The detailed version (such as options other than brief under show mpls ldp tunnel) lists the ports,
one in each line.
Command
output
The show mpls ldp tunnel brief command displays the following information.
Output field Description
Number of LDP tunnels Number of LDP tunnels
To The egress LER for the LSP.
Oper State Operational state of the LSP.
Tunnel Intf The tunnel interface of the LSP.
Outbound Intf The out-interface that corresponds to the next-hop configured.
The show mpls ldp tunnel detail command displays the following information.
Output field Description
LDP Tunnel Name of the tunnel.
Tunnel index Tunnel index of the current tunnel.
metric Metric value for the tunnel.