Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 180)

156 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Static transit LSP
1
Show Commands
The following show commands are available to display static-LSP information.
Show mpls static-lsp
The show mpls static-lsp command displays the static-LSPs in the system in brief.
Brocade# show mpls static-lsp
Number of transit lsps: 2
Name Admin Oper In-label Out-label Next-hop Out-Intf
c2 UP DOWN 21 1024 160.168.123.122 e2/1
c3 UP UP 22 3 160.168.111.100 ve10
TABLE 7 show mpls static-lsp field definitions
Field Definition
Name Name of the static LSP as configured by the user
Admin Whether the static LSP is enabled or not
Oper Operational state of the LSP
In-label The in-label configured for the LSP
Out-label The out-label configured. If none, the implicit-null label 3 is shown.
Next-hop The configured next-hop.
Out-Intf The out-interface that corresponds to the next-hop configured.
Syntax: show mpls static-lsp [up | down]
Show mpls static-lsp
The show mpls static-lsp can be configured to display a detailed output for a specific static-LSP
name or can display an extensive output.
Brocade# show mpls static-lsp extensive
Static-LSP t1, Role: Transit
Enabled: Yes, UP: Yes
Times LSP goes up since enabled: 1
In-label: 201, Out-label: 3,
Next-hop: 120.120.120.2,
Out-Interface for the next-hop: e2/1
Next-hop interface address to reach configured next-hop: 10.1.1.2
History
0 Jul 11 01:38:32 : LSP tunnel is Enabled
1 Jul 11 01:38:33 : Static Transit LSP UP
Static-LSP t2, Role: Transit
Enabled: Yes, UP: No
LSP error: No interface available for next-hop
Times LSP goes up since enabled: 1
In-label: 202, Out-label: 3,
Next-hop: 20.1.1.2,
Out-Interface for the next-hop: --