Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 295)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 271
53-1003031-02
Transit LSP statistics
1
Clearing MPLS RSVP sessions
To clear only the RSVP statistics transit counters, enter the following command:
Brocade# clear mpls statistics rsvp session 10.2.2.2 10.1.1.1 5
Syntax: clear mpls statistics rsvp session destination ip address / source ip address / tunnel id
Where the destination ip address specifies the destination IP address of session object.
Where the source ip address specifies the source ip address of session object.
Where the tunnel id specifies the tunnel ID of session object.
Clearing MPLS LDP transit statistics
To clear the transit traffic statistics for the specified LDP FEC, enter the following command.
Brocade# clear mpls statistics ldp transit fec 10.3.3.3/32
Syntax: clear mpls statistics ldp transit fec ip address| subnet mask length
Where the ip address is the IP address configured on this interface.
Where the subnet mask length specifies the network prefix mask length.
Clearing MPLS label statistics
To clear the traffic statistics for the specified incoming label, enter a command such as the
following.
Brocade# clear mpls statistics label 2032
Syntax: clear mpls statistics label [in-label]
The in-label variable allows the user to specify the label value.
Sample configurations
To set the counter-mode to packet on the NetIron CES or NetIron CER, enter the following
commands.
Brocade(config)# router mpls
Brocade(config-mpls)# counter-mode
Brocade(config-mpls)# counter-mode packet
To verify the configuration, enter the following command.
Brocade(config-mpls)# show mpls configuration
router mpls
counter-mode packet
mpls-interface e1/11