Commands – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 459
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
435
53-1003031-02
Commands
2
Brocade# show mpls ldp path
Destination route Upstr-session(label) Downstr-session(label, intf)
10.2.2.2/32
10.1.1.1:0(3)
10.1.1.1/32
10.1.1.1:0(3, e1/1)
10.1.1.1:0(3, e1/2)
10.3.3.3/32
10.3.3.3:0(5050) 10.4.4.4:0(2057,gre-tnl200)
Brocade# show mpls ldp path 10.22.22.22
Destination route Upstr-session(label) Downstr-session(label, intf)
10.22.22.22/32 10.44.44.44:0(1024) 10.22.22.22:0(3, e2/3 (Trunk11)
Brocade# show mpls ldp path 10.33.33.33/32
Destination route Upstr-session(label) Downstr-session(label, intf)
10.33.33.33/32 10.44.44.44:0(1025) 10.44.44.44:0(1024, ve55)
10.22.22.22:0(1041, e2/3 (Trunk11)
Syntax: show mpls ldp path [path-ip-address [ip-mask]]
The user can view a prefix list by entering the show mpls ldp fec prefix command.
Brocade# show mpls ldp fec prefix
Total number of prefix FECs: 3
Destination State Out-intf
Next-hop Ingress Egress
10.2.2.2/32 current --
--
No Yes
10.1.1.1/32 current e1/2
10.22.22.22
Yes No
e1/1
10.11.11.11
10.3.3.3/32 current gre-tnl200 10.33.33.33 No No
Syntax: show mpls ldp fec prefix
The user can view the MPLS RSVP state and settings by entering the show mpls rsvp interface
command.
NOTE
MP switchover event may not be handled properly by MPLS/RSVP module. This may result in
inconsistent state for RSVP LSPs/Sessions. This could be fixed by adding support for RSVP Hello
feature.
Brocade# show mpls rsvp interface
Interface State MD5 Auth
e1/1 Up OFF
e1/2 Up OFF
Syntax: show mpls rsvp interface
Commands
The following commands support the features described in this chapter:
•