Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 704)

Brocade# show ip bgp vrf black neighbor 10.10.2.3 attribute-entries
Total number of BGP Attribute Entries: 2
1 Next Hop :10.10.2.3 Metric :0 Origin:IGP
Originator:0.0.0.0 Cluster List:None
Aggregator:AS Number :0 Router-ID:0.0.0.0 Atomic:None
Local Pref:100 Communities:Internet
AS Path :310
Address: 0x2470139c Hash:223 (0x0100036e) Reference Counts: 30:0:60
2 Next Hop :10.2.2.2 Metric :2 Origin:INCOMP
Originator:0.0.0.0 Cluster List:None
Aggregator:AS Number :0 Router-ID:0.0.0.0 Atomic:None
Local Pref:100 Communities:Internet
Extended Community: RT 600:1 OSPF DOMAIN ID:0.0.0.0 OSPF RT 0:5:1 OSPF ROU
ID:0.0.0.0
AS Path :
Address: 0x24702310 Hash:992 (0x03000000) Reference Counts: 0:0:90
680 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying BGP or MPLS VRF information
6
Syntax: show ip bgp vrf-name attribute-entries
This display shows the following information.
TABLE 126 BGP4 route-attribute entries information
This field... Displays...
Total number of BGP Attribute Entries The number of routes contained in this Brocade device’s BGP4 route
table.
Next Hop The IP address of the next hop router for routes that have this set of
attributes.
Metric The cost of the routes that have this set of attributes.
Origin The source of the route information. The origin can be one of the
following:
•
EGP – The routes with this set of attributes came to BGP through
EGP.
•
IGP – The routes with this set of attributes came to BGP through
IGP.
•
INCOMPLETE – The routes came from an origin other than one of
the above. For example, they may have been redistributed from
OSPF or RIP.
When BGP4 compares multiple routes to a destination to select the best
route, IGP is preferred over EGP and both are preferred over
INCOMPLETE.
Originator The originator of the route in a route reflector environment.
Cluster List The route-reflector clusters through which this set of attributes has
passed.
Aggregator Aggregator information:
•
AS Number shows the AS in which the network information in the
attribute set was aggregated. This value applies only to aggregated
routes and is otherwise 0.
•
Router-ID shows the router that originated this aggregator.