Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 182)

158 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Static transit LSP
1
Syntax: show mpls label-range
Show mpls config static-lsp transit
This command displays the configuration stored in the show run command but restricted to the
static LSPs configured:
Brocade# show mpls config static-lsp transit t1
static-lsp transit t1
in-label 100
out-label 101
next-hop 10.1.1.2
enable
Syntax: show mpls config static-lsp transit lsp-name
Show mpls summary
The output of the show mpls summary command now displays static-configured LSPs.
Brocade# show mpls summary
Path:
Paths configured = 1
RSVP-Signaled LSPs:
LSPs configured = 2
LSPs enabled = 2
LSPs operational = 1
Detour LSPs UP = 0
Backup LSPs UP = 0
Bypass LSPs = 1
Bypass LSPs UP = 0
LDP-Signaled LSPs:
LSPs operational = 0
Static-LSPs:
Transit-LSPs configured = 12
Transit-LSPs enabled = 11
Transit-LSPs operational = 9
VPLSs:
VPLSs configured = 0
VPLS peers = 0
Peers operational = 0
VLLs:
VLLs configured = 0
Dynamic Represents the dynamic label range for transit labels.
Modified label range This header displays the values that have been configured, but not yet
effective as label range changes require a reload. This section is visible only
if a different set of values have been configured to take effect after reload.
TABLE 9 show mpls label-range field definitions
Field Definition