Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 270)

246 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying the Traffic Engineering database
1
Displaying the P2MP hardware forwarding information
The show mpls lsp_p2mp_xc command is introduced to display information about the forwarding
information of hardware that is allocated for the point-to-multipoint (P2MP) cross-connect.
Brocade# show mpls lsp_p2mp_xc 1159
TOTAL OUT_SEGS under the given in_label = 1
BRANCH-ID OUT-LABEL OUT-PORT NH-ID
0 0 14 6
Event History -
Tue Aug 14 02:21:54 2012 P2MP BRANCH ADD
Tue Aug 14 02:21:54 2012 P2MP XC ADD
flag: 0, pool_index:1, avail_data:270e0800
Syntax: lsp_p2mp_xc in_label
in_label specifies the MPLS input label value.
Displaying RSVP information
The user can display RSVP version information, the status of RSVP interfaces, RSVP session
information, and RSVP statistics.
in-intf The interface through which the label identified in the in-lbl column has been received for the
LSP. A value of 0 indicates the absence of the segment. When applicable, the in-intf field also
displays a VE interface specified by the variable.
out-lbl The outgoing segment or downstream label for the LSP.
out-intf The interface through which the label identified in the out-lbl column has been distributed for
the LSP. The out-intf field displays whether an interface/port is an Ethernet port, POS port, or a
VE interface. The VE interface ID specified by the vid variable.
The out-intf display format for interface/port is as follows:
•
[e|p] slot/port
“e” represents an Ethernet port
“p” represents a POS port
sig The signal protocol type associated with the label. Possible values are:
•
L – LDP
•
R – RSVP
next-hop The next hop of the LSP.
DET DET specifies that this is a Detour path.
TABLE 26 Output from the show mpls forwarding command (Continued)
This field... Displays...