Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 279)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 255
53-1003031-02
Displaying the Traffic Engineering database
1
The ppend option displays sessions in the soft preemption pending state.
The s2l option displays P2MP source to leaf sub-LSPs.
The transit option limits the display to transit P2MP sessions.
The up option limits the display to an active P2MP session.
The wide option displays long LSP names.
Displaying RSVP statistics
The device constantly gathers RSVP statistics. RSVP statistics are collected from the time RSVP is
enabled, as well as from the last time the RSVP statistics counters were cleared.
To display RSVP statistics.
Brocade# show mpls rsvp statistics
Total Since last clear
PacketType Sent Received Sent Received
Path 4 4 4 4
Resv 4 4 4 4
PathErr 0 0 0 0
ResvErr 0 0 0 0
PathTear 0 0 0 0
ResvTear 0 0 0 0
ResvConf 0 0 0 0
Errors Total Since last clear
Rcv pkt bad length 0 0
Rcv pkt unknown type 0 0
Rcv pkt bad version 0 0
Rcv pkt bad cksum 0 0
Memory alloc fail 0 0
Rcv pkt processing error:
Path 0 0
Resv 0 0
PathErr 0 0
ResvErr 0 0
PathTear 0 0
ResvTear 0 0
ResvConf 0 0
Syntax: show mpls rsvp statistics
The following table describes the output of the show mpls rsvp statistics command.
TABLE 31 Output from the show mpls rsvp statistics command
This field... Displays...
Path The number of Path messages sent and received. Path messages store information about the
state of the path along the LSRs in the LSP.
Resv The number of RESV messages sent and received. RESV messages include FF (Fixed Filter), WF
(Wildcard Filter), and SE (Shared Explicit) messages.
PathErr The number of PathErr messages sent and received.
ResvErr The number of ResvErr messages sent and received.