Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 204)

180 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Dynamic Bypass LSPs
1
Number of active riding ingress backup lsps: 0
Number of inactive riding ingress backup lsps: 1
Syntax: show mpls bypass-lsp static [brief |detail |extensive|interface ethernet lsp_name]
• The show mpls bypass-lsp command is modified to include filtering based of static bypass
types, dynamic bypass types and protected interface.
• The show mpls summary (brief) command output is modified to have an entry for total number
of bypass LSPs in the system.
• The show mpls lsp [detail | extensive ] command output is modified such that for metric field
does not display for static bypass and dynamic bypass LSPs.
Use the lsp_name parameter to select the name of the LSP to display.
Displaying dynamic bypass information
The show mpls dynamic-bypass interface command has three fields: Active Status, Admin Type,
and Admin Status.
• Admin Type: Indicates dynamic bypass configuration on the interface is because of local
(interface) or global (MPLS device) mode configuration.
• Admin Status: Indicates when the user has enabled the dynamic bypass on the interface. UP
indicates interface dynamic bypass is admin config enabled, DOWN implies admin config
disabled. This admin config represents user explicit interface config (when present), otherwise
enable-all-interfaces (when present).
• Active Status: Enabled indicates net effect of global and local configuration enable leads to
status is UP. Disabled indicates either local or global admin is DOWN and net effect is disabled
add admin status.
Displaying dynamic bypass information for an interface
Use the show mpls dynamic-bypass command to display bypass LSP information on a specific
interface.
Brocade# show mpls dynamic-bypass interface detail
Dynamic bypass interface: e2/15, Active status: Enabled
Admin type: Local, admin status: UP
Hop limit: 255, Tie-breaking: random, cos: 0
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
From: 10.11.11.11, reoptimize timer: 0 secs
Adaptive: Yes, record route: enabled
Name prefix: dbyp, primary path: none
Max bypass per merge point: 111, total bypasses: 0
Total number of merge points 0
Dynamic bypass interface: e3/1, Active status: Enabled
Admin type: Global, admin status: UP
Hop limit: 255, Tie-breaking: random, cos: 0
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
From: 10.11.11.11, reoptimize timer: 0 secs
Adaptive: Yes, record route: enabled