Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 707)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 683
53-1003031-02
Displaying BGP or MPLS VRF information
6
Syntax: show ip bgp vrf vrf-name neighbor ip-addr routes best
For information about the fields in this display, refer to Table 121 on page 667.
Displaying the best routes that were nonetheless not installed in the IP route table
To display the BGP4 routes received from a specific neighbor that are the “best” routes to their
destinations but are not installed in the Brocade device’s IP route table, enter a command such as
the following at any level of the CLI.
Brocade# show ip bgp vrf black neighbor 192.168.4.211 routes not-installed-best
Each of the displayed routes is a valid path to its destination, but the Brocade device received
another path from a different source (such as OSPF, RIP, or a static route) that has a lower
administrative distance. The Brocade device always selects the path with the lowest administrative
distance to install in the IP route table.
Syntax: show ip bgp vrf vrf-name neighbor ip-addr routes not-installed-best
For information about the fields in this display, refer to Table 121 on page 667.
Displaying the routes whose destinations are unreachable
To display BGP4 routes whose destinations are unreachable using any of the BGP4 paths in the
BGP4 route table, enter a command such as the following at any level of the CLI.
Brocade# show ip bgp vrf black neighbor 192.168.4.211 routes unreachable
Syntax: show ip bgp vrf vrf-name neighbor ip-addr routes unreachable
For information about the fields in this display, refer to Table 121 on page 667.
Displaying the Adj-RIB-Out for a VRF neighbor
To display the Brocade device’s current BGP4 Routing Information Base (Adj-RIB-Out) for a specific
VRF neighbor and a specific destination network, enter a command such as the following at any
level of the CLI.