Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 74)

50 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
show mpls lsp detail/extensive
1
mean rate The average rate of packets that can go through the LSP (in kbps), set with the
traffic-eng mean-rate command.
max burst The maximum size (in bytes) of the largest burst the LSP can send at the maximum
rate,
set with the traffic-eng max-burst command.
mode Mode will tell is the LSP is in monitor-only or monitor-and-signal mode.
adjustment threshold Displays the configured adjustment-threshold value.
minimum bw The configured minimum bandwidth.
maximum bw The configured maximum bandwidth.
overflow limit Displays the configured overflow-limit value.
underflow limit The number of sample which have to be below the threshold to trigger a premature
adjustment.
sample-record Whether the template is set to record the sample history.
Constraint-based
routing enabled Whether CSPF is in effect for the LSP.
Path calculated using
constraint-based routing: Whether the explicit path used by the active path was calculated using the
constraint-based routing.
Path calculated using
interface constraint:
Whether the explicit path used by the active path was calculated using the
interface-constraint routing.
Path cost: The total cost of this path.
Tie breaking The tie-breaking method CSPF uses to select a path from a group of equal-cost paths
to the egress LER, set with the tie-breaking command.
LDP tunneling enabled: If LDP tunneling is enabled, the line reads “yes.” If it is not enabled, the line reads
“no.”
Soft preemption enabled: Soft preemption minimizes traffic disruptions and gracefully reroute the preempted
LSPs.
Sec. path The name of the secondary path for this LSP and whether the path is currently active.
active: Displays if the secondary path is active.
Hot-standby Whether the secondary path is a hot-standby path.
status The operational state of the secondary path.
Setup priority The configured setup priority for the LSP.
hold priority The configured hold priority for the LSP.
Max rate The maximum rate of packets that can go through the LSP (in kbps), set with the
traffic-eng max-rate command.
mean rate The average rate of packets that can go through the LSP (in kbps), set with the
traffic-eng mean-rate command.
max burst The maximum size (in bytes) of the largest burst the LSP can send at the maximum
rate,
set with the traffic-eng max-burst command.
mode Mode will tell is the LSP is in monitor-only or monitor-and-signal mode.
adjustment threshold: Displays the configured adjustment-threshold value.
Field output Description