Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 179)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 155
53-1003031-02
Static transit LSP
1
Enable
The enable command is used to enable the LSP configuration to bring up the LSP to allow
forwarding to use the labels. It checks whether the configuration is valid - the in-label and the
next-hop are configured - and then tries to bring up the LSP. Bring-up of the LSP can fail due to
many reasons such as the out-interface not UP or the next-hop not valid.
Brocade(config-mpls-static-transit-lsp-t1)# enable
Syntax: enable
Disable
The disable command is used to disable the LSP configuration. Disabling will remove the labels
from the forwarding layers and the LSP cannot be used to forward packets anymore. It will allow the
user to change any configuration in the LSP before enabling again. Labels are not deallocated
though and it will be an error to use the same in-labels as on a disabled or enabled LSP.
Brocade(config-mpls-static-transit-lsp-t1)# disable
Syntax: disable