Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 256)

232 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
show mpls statistics ldp tunnel [dec|vif-index]
1
show mpls statistics ldp tunnel [dec|vif-index]
This is an existing command (in NI R05.500). No change is made to its syntax. The output of this
command now shows the total combined statistics of all ECMP paths of an LDP tunnel with LDP
ECMP LER feature.
Syntax show mpls statistics ldp tunnel [dec|vif-index]
Parameters dec
The dec keyword is the destination prefix.
vif-index
The vif-index keyword displays the total combined statistics of all ECMP paths of an LDP tunnel
with LDP ECMP LER feature.
Command
modes
Global configuration.
Usage guidelines The statistics will not be accurate if the system runs out of CAM entries for all the ECMP paths. This
could potentially happen in NI 05.500 as well so there is no change made from that behavior.
Command
output
Output field Description
LSP The name of the LSP that statistics are being displayed for. (Displayed for RSVP-signaled
LSPs only.)
tnl The index number of the MPLS tunnel.
pkt The total number of packets forwarded through the specified LSP.
Byte The total number of bytes forwarded through the specified LSP.
Avg. pps The number of packets-per-second forwarded through the specified LSP.
Avg. Bps The number of bytes-per-second forwarded through the specified LSP.
The show mpls statistics ldp tunnel [vif-index] command displays the following information.
Example
Brocade# show mpls statistics ldp tunnel
LDP tunnel interface tnl13 0 pkt 0 Byte 0 Avg. pps 0 Avg. Bps
History
Release Command history
Multi-Service NetIron Release 05.600 The output of this command now shows the total combined statistics of all
ECMP paths of an LDP tunnel with LDP ECMP LER feature.
Multi-Service NetIron Release 05.500c The output of this command now shows the total combined statistics of all
ECMP paths of an LDP tunnel with LDP ECMP LER feature.
Related
commands
None.
Clearing LSP and LDP accounting statistics
Byte and packet counters can be cleared for RSVP-signaled LSPs using the following command.
Syntax: clear mpls statistics lsp [name]