Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 831
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
807
53-1003031-02
Displaying 6PE information
9
BFD:Disabled
TCP Connection state: ESTABLISHED, flags:00000044 (0,0)
Maximum segment size: 1460
TTL check: 0, value: 0, rcvd: 62
Byte Sent: 981, Received: 962
Local host: 10.40.40.1, Local Port: 179
Remote host: 10.30.30.1, Remote Port: 8167
ISentSeq: 3437281442 SendNext: 3437282424 TotUnAck: 0
TotSent: 982 ReTrans: 0 UnAckSeq: 3437282424
IRcvSeq: 3443025033 RcvNext: 3443025996 SendWnd: 64981
TotalRcv: 963 DupliRcv: 0 RcvWnd: 65000
SendQue: 0 RcvQue: 0 CngstWnd: 3102
Syntax: show ip bgp 6pe neighbors ip-address
The ip-address parameter allows the user to display information for a specified neighbor.
The information related to the 6PE neighbors is shown in bold text in the previous output.
describes the output parameters of the show ip bgp 6pe neighbors command.
TABLE 156
Output parameters of the show ip bgp 6pe neighbors command
Field
Description
Total number of
BGP Neighbors
Shows the total number of BGP neighbors.
IP Address
Shows the IPv4 address of the neighbor.
AS
Shows the Autonomous System (AS) in which the neighbor resides.
EBGP or IBGP
Shows whether the neighbor session is an IBGP session, an EBGP session, or a confederation
EBGP session:
•
EBGP – The neighbor is in another AS
•
EBGP_Confed – The neighbor is a member of another sub-AS in the same confederation
•
IBGP – The neighbor is in the same AS
RouterID
Shows the router ID of the neighbor.
VRF
Shows the status of the VRF instance.