Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 569)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 545
53-1003031-02
Clearing VLL extended counters
4
The ethernet port-id parameter specifies the port ID of the interface for which the user wants to
display the counters.
Table 86 describes the output parameters of the show mpls statistics vll extended-counters
command.
TABLE 86 Output of the show mpls statistics vll extended-counters command
Field Description
VLL The configured name for a VLL instance.
VLL-ID The ID of the VLL instance.
VLAN The ID of the configured VLAN.
Port The port ID of the interface for which the user wants to display the counters.
RxPkts The number of packets received at the specified port.
TxPkts The number of packets transmitted from the specified port.
RxBytes The number of bytes received at the specified port.
TxBytes The number of bytes transmitted from the specified port.
Clearing VLL extended counters
To clear all the port VLAN counters for a particular VLL instance, enter the following command.
Brocade# clear mpls statistics vll vll78 extended-counters
To clear all the port VLAN counters for a particular VLL instance and port under a specific VLL
VLAN, enter the following command. This command is supported only for a single VLAN instance
and is not supported for dual tag endpoints.
Brocade# clear mpls statistics vll vll78 extended-counters vlan 74
To clear all the port VLAN counters for all the endpoints of a particular VLL instance, enter the
following command. When the VLL endpoint is a Link Aggregation Group (LAG), then the counters
only for the given physical port are cleared.
Brocade# clear mpls statistics vll vll78 extended-counters vlan 74 ethernet 5/2
To clear all the port VLAN counters for the given priority of a particular VLL endpoint, enter the
following command.
Brocade# clear mpls statistics vll vll78 extended-counters vlan 74 ethernet 5/2 p1
Syntax: clear mpls statistics vll [vll-name | vll-id [extended-counters [[vlan vlan-id] [ethernet
port-id [priority pri]]]]]
The vll-name parameter specifies the configured VLL name for which the user wants to clear the
counters.
The vll-id parameter specifies the ID of a VLL instance for which the user wants to clear the
counters.