Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 262)

238 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying the Traffic Engineering database
1
When an out of range parameter value is entered, the following error message is displayed for the
priority parameter.
Priority
Error - Setup priority value is out of range [0 - 7]
The following table describes the output of the show mpls ted path command.
TABLE 21 Output from the show mpls ted path command
This field... Displays...
Path to10.4.4.4
found The IPv4 address of the destination host is found.
Time taken to
compute The total time taken by CSPF (in milliseconds) to compute this path.
Hop-count The hop count of this path.
Cost The total cost of this path.
IS-IS The IS-IS or OSPF or CSPF area ID through which this path traverses.
Hop The ingress interface IPv4 address at each hop.
Rtr The traffic engineering router ID (IPv4 address) at each hop.
Displaying signaled LSP status information
The user can display status information about signaled LSPs for which the device is the ingress LER
as shown in the example below.
Brocade# show mpls lsp
*: The LSP is taking a Secondary Path
Admin Oper Tunnel Up/Dn Retry Active
Name To State State Intf Times No. Path
t1 10.3.3.3 UP UP* tnl1 1 5 v2
Syntax: show mpls lsp [brief]
NOTE
The show mpls lsp brief command displays the same information as the show mpls lsp command.
Table 22 describes the output of the show mpls lsp command.
TABLE 22 Output from the show mpls lsp command
This field... Displays...
Name The name of the LSP. LSPs are displayed in alphabetical order.
To The egress LER for the LSP.
Admin State The administrative state of the LSP. Once the user activates the LSP with the enable command,
the administrative state changes from DOWN to UP.