Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 381)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 357
53-1003031-02
MPLS LDP-IGP synchronization
2
Brocade(conf-router-mpls-ldp-eol)# notification-timer
Syntax: EOL notification timer value
The value parameter specifies the length of the EOL notification timer in milliseconds. Possible
values are from 100 to 120000 milliseconds. The default value is 60000.
Setting the EOL transmit label silence timer
Use the tx-label-silence-timer command under conf-router-mpls-ldp-eol policy to sets the length of
the EOL transmit label silence timer. This command is LDP global.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib
Brocade(conf-router-mpls-ldp-eol)# tx-label-silence-timer 2000
Syntax: tx-label-silence-timer value
The value parameter specifies the length of the EOL transmit label silence timer in milliseconds.
Possible values are from 100 to 60000 milliseconds. The default value is 1000.
Displaying LDP IGP synchronization information
Use the show isis config | show ip ospf config commands under config-isis-router | config-ospf
config policies to show the new configuration parameters for LDP-IGP sync:
• enable/disable for LDP-IGP sync
• Hold down time
Use the show isis configuration command to displaying IS-IS LDP IGP synchronization information.
Brocade(config-isis-router)# show isis config
router isis
net 11.0010.0100.1002.00
log adjacency
address-family ipv4 unicast
ldp-sync
metric-style wide
ldp-sync
ldp-sync hold-down 300
redistribute connected level-1
redistribute static
exit-address-family
address-family ipv6 unicast
ldp-sync
multi-topology transition
exit-address-family
end
Syntax: show isis configuration