Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 380)

356 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
MPLS LDP-IGP synchronization
2
Setting the receive label silence timer
When labels are not received from the peer for a short period of time, the session is declared ‘In
Sync’. When a label is received from a peer, then the ‘receive label silence timer’ is reset.
Use the rx-label-silence-time command under config-mpls-ldp policy to define the length of the
receive label silence timer.
Brocade(conf)# router mpls
Brocade(config-mpls)# ldp
Brocade(config-mpls-ldp)# rx-label-silence-time 30000
Syntax: rx-label-silence-time value
The value parameter specifies the length of time of the receive label silence timer in milliseconds.
Possible values are from 100 to 60000 milliseconds. The default value is 1000.
Enabling the end-of-lib submode
Configure the end-of-lib submode under LDP to contain all the attributes of the end of lib capability
and notification.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib
Brocade(conf-router-mpls-ldp-eol)#
Enabling the end-of-lib submode
Enabling the end-of-lib submode determines whether the two RFCs 5561 and 5919 are enabled by
the LSR. The user can turn this feature off either by;
• Removing the end-of-lib submode
• Issuing the disable command under the end-of-lib submode.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib
Brocade(conf-router-mpls-ldp-eol)# disable
Syntax: [no] end-of-lib
The [no] form of “disable” enables the feature.
Setting the EOL notification timer
Use the EOL notification timer command under the conf-router-mpls-ldp-eol policy to set the length
of the EOL notification timer. This command is LDP global.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib