Sample configurations – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 329
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
305
53-1003031-02
LDP Inbound-FEC filtering
2
Upstream label database:
Label
Prefix
3
10.44.44.44/32
1024
10.66.66.66/32
Session 10.44.44.44:0 - 10.66.66.66:0
Downstream label database:
Label
Prefix
State
3
10.66.66.66/32 Installed
Upstream label database:
Label Prefix
3
10.44.44.44/32
1025 10.14.14.14/32
Refer to
for additional information.
show mpls ldp session detail
Use the show mpls ldp session detail command to display the number of FECs from the peer which
are filtered due to the inbound FEC filter configuration.
Brocade(config)# show mpls ldp sesion detail
Number of link LDP sessions: 1
Number of Operational link LDP sessions: 1
Number of targeted LDP sessions: 0
Number of Operational targeted LDP sessions: 0
Peer LDP ID: 10.66.66.66:0, Local LDP ID: 10.44.44.44:0, State: Operational
Adj: Link, Role: Passive, Next keepalive: 2 sec, Hold time left: 32 sec
Keepalive interval: 6 sec, Max hold time: 36 sec
Configured keepalive timeout: 36 sec
Peer proposed keepalive timeout: 36 sec
Up time: 21 sec
Neighboring interfaces: e4/2
TCP connection: 10.44.44.44:646--10.66.66.66:9075, State: ESTABLISHED
Number of FECs installed from peer: 5
Number of FECs filtered from peer: 1
Next-hop addresses received from the peer:
10.1.1.2 10.66.66.66 10.168.1.1 10.168.1.2 10.168.1.3 10.168.1.4 10.168.1.5
IGP Sync:
Local State: In-sync, RemoteState: -
EOL mechanism not used.
Receive label silence time remaining: 0 seconds
Graceful restart: enabled
Peer reconnect time(msec): 120000, peer recovery time(msec): 120000
State: not started
Refer to
for additional output information.
Sample Configurations
The following examples use the FEC filtering parameter:
Consider three MPLS router system devices with an ID 10.66 with the transit device between them.
FIGURE 45
Inbound FEC filtering example