Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 289)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 265
53-1003031-02
Displaying the Traffic Engineering database
1
ipmtu 1028
traffic-eng max-rate 180 mean-rate 125
metric 5
shortcuts ospf
frr
bandwidth 80
hop-limit 55
enable
lsp lsp13d
to 10.3.3.2
primary mu1_to_mu3
cos 7
traffic-eng max-rate 250 mean-rate 120
no cspf
enable
lsp lsp12d
to 10.1.1.2
cos 7
traffic-eng max-rate 100 mean-rate 50
enable
vll c13 5500
vll-peer 10.33.33.1
vlan 200
tagged e 1/3
vll-local l15
vlan 32
untag e 1/4
cos 4
vpls vpmaster 22
vpls-peer 10.66.66.2
vlan 110
multicast active
multicast pimsm-snooping
end of MPLS configuration
Syntax: show mpls config
Displaying MPLS configuration information for a VE interface
The show mpls config command and show running-config command display specific MPLS
interface configuration information. When MPLS is configured on a VE interface, the VE interface ID
is displayed in the output of the show mpls config command and the show running-config
command.
The show mpls config interface command allows the user to display configuration information for
an MPLS-enabled interface. The user can specify a VE interface on the CLI. The following example
displays CLI commands executed for interface ve 20.