Rockwell Automation GMLC Reference Manual - Manual (Page 948)

Publication GMLC-5.2 - November 1999
Index 911
Opposite direction gearing 214
optional configurations 44
Optional masks 620
Optional Novice Mode 4
Other default conditions 812
Output 625
Output bits, defining 763, 789
Output block 291
Output Cam block 291
enable output cams
actuation delay 295
camming to actual position 293
camming to command position 293
camming to the imaginary axis 293
Output floats, defining 764, 790
Output limit status 583
outputs, defining, See defining inputs and
outputs
Override profile 207, 210
P
palette 23
palette comparison
3.8 and Commander
Multidrop 887
parameter
finding specific 151
Passive Homing 81
Passive homing 196
password 35
Pausing moves 243
PCAM auto correction distance to go 487
PCAM average registration error 490
PCAM good registration count 491
PCAM missing registration count 492
PCAM registration error 488
Phase shift and incremental auto correction
255
Phase shift moves 202
PLC data file, constructing the 708
Position error 484
Position error tolerance fault 515
Position lock Cam auto-correction status
581
Position Lock CAM block 274
Position Lock Cam block
master reference position 278
moving while camming 283
Position-lock Cams and the imaginary
axis 276
scaling position-lock cams 281
selecting a position-lock cam direction
278
slaving to the actual position 277
slaving to the command position 277
synchronizing position-lock cams on
multiple axes 280
unidirectional position-lock cams 280
Virtual master axes 276
Position lock Cam pending profile status
581
Position lock Cam profiling status 580
Position lock Cam status 580
Position-lock Cams and the imaginary axis
276
Position-lock Cams, or interpolated motion
819
preface 1
Prerequisite knowledge 1
Print Diagram dialog box 26
Print to Display block 410
force to port 411