Rockwell Automation GMLC Reference Manual User Manual
Page 5
Publication GMLC- 5.2 - November 1999
ii
Table of Contents
Naming a Module ............................................................. 25
Printing ..............................................................................26
Printing a Diagram ......................................................27
Diagram Scaling .........................................................27
Chapter 2 – Configuring Control Options
Defining a Diagram’s Configuration Settings ..................29
Understanding the Precedence of Changing Setup
Parameters .............................................................29
Using the Settings from an Existing Diagram ............30
Selecting Settings for a New Diagram ........................30
Setting Control Options .............................................31
Setting General Control Options ...........................31
Setting the Axes ................................................................35
Setting the Serial Port Interface .......................................37
Setting the Flex I/O ..........................................................39
Defining Flex I/O ........................................................40
Setting the Smart Power Options ......................................42
Setting Optional Configurations .................................44
Configuring Your Remote I/O Interface ...........................46
Configuring the RIO ...................................................47
Configuring Your CNET Interface ...................................49
Configuring Your SLC Interface ......................................51
Configuring the AxisLink Interface ..................................54
Configuring the DH-485 Interface ....................................56
Configuring the Multidrop Interface .................................58
Chapter 3 – Configuring Axis Use
Copying an Existing Axis Configuration ....................59
To Configure an Axis With the Axis Use Screens .....61
General ..............................................................................62
Physical Axis ........................................................62
Axis Type ..............................................................63
Position Mode .......................................................63
Drive Interface Module Axis ................................63
Defining Units ...................................................................64