Rockwell Automation GMLC Reference Manual - Manual (Page 62)

Publication GMLC-5.2 - November 1999
Naming a Block 25
Naming a Block
When you first create a block, the description below it is generic. You can
rename it using a descriptive name reflecting the block’s function within
this diagram. When you place the block, the description below it is
highlighted. Click on the name area below the block and then type in the
name you prefer. Clicking anywhere on the diagram releases the block.
Naming a Module
When you create a module, GML Commander assigns it the name New
Module x. You can rename it using a descriptive name to reflect the
module’s function. To rename the module, highlight the name area by
clicking on it with the mouse and then type in the preferred name. To
release the module, click any blank area in the diagram.