Rockwell Automation 20P PowerFlex DC Drive - Frame D Switching Power Supply Circuit Board User Manual
Rockwell Automation Equipment
PowerFlex® DC Drive
Frame D Switching Power Supply Circuit Board
Installation Instructions
What This Kit Includes
•
Switching Power Supply circuit board
•
16 Pin Ribbon cable
•
Five screws with captive lock washers
•
Static strap
Tools That You Need
•
Phillips
®
screwdriver
•
Hexalobular screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
What You Need to Do
To install the switching power supply board:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the protective covers
❐ Step 3: Remove the existing switching power supply board
❐ Step 4: Install the new switching power supply board
❐ Step 5: Replace the protective covers and document the change
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.