Rockwell Automation GMLC Reference Manual - Manual (Page 897)

Publication GMLC-5.2 - November 1999
860 Data Parameters and Data Bits
The following tables are listed by the data parameter or data bit
description displayed in Commander when a Control options Block is
selected. They are arranged alphabetically. Some data parameters and
bits are dependent on whether Read, Show, or Adjust is selected in the
Type field of the Control Options screen.
Data Parameters Table
In the following table, the Value Format column displays the required
numerical format for the value. A Value Format of the form X.Y means
that up to X total digits, with Y digits to the right of the decimal point,
may be used to specify the value. Do not enter values which do not fit the
selected format or unpredictable operation may occur. Parameters marked
with an asterisk (*) are not axis-specific. The Default column of this table
displays the value that is set when the i
CODE .I command is executed and
the controller reset.
!
ATTENTION: We recommend using extreme caution
when configuring the Adjust Control Settings type
block, because carelessly changing certain Data Bits or
Data Parameters can cause uncontrolled motion.
ATTENTION: Do not enter adjusting values for data
parameters that do not fit the selected parameter’s Value
Format. See the Reference Manual for each parameter’s
Value Format.