beautypg.com

Setting control options – Rockwell Automation GMLC Reference Manual User Manual

Page 68

background image

Publication GMLC-5.2 - November 1999

Defining a Diagram’s Configuration Settings

31

Note: All options on this menu are part of the setup procedure. You can

use these options later during testing and monitoring processes to
make changes.

2. Select Control Options. The Configure Control Options dialog box

appears.

3. To set the Control Options, follow the steps in the following section.

Setting Control Options

You configure the control options for the controller from the Configure
Control Options dialog box.

Basic information required for all diagrams is presented on the General,
Axes, and Interface tabs. Selections on the General tab can display
additional tabs containing further options.

The tasks performed from this menu are:

Setting the control type

Setting the basic communications interfaces

Setting the application options

Defining the setups password

Setting General Control Options

To set control options for your controller:

1. Select Configure from the menu bar. The Configure menu appears.

2. Select Control Options. When the Configure Control Options dialog

box displays, the basic tabs appear. The example below shows this
dialog box before configuration settings are selected.