Rockwell Automation GMLC Reference Manual - Manual (Page 933)

Publication GMLC- 5.2 - November 1999
896 Index
Accessing from Edit menu 146
Aligning 143
color codes 23
copy to Clip Board 141
GML 3.x
comparison to GML Commander
875
GML Commander
comparison to GML 3.x 875
Snap to Grid option 145
Spacing 144
breakpoint, inserting 158
Build Table block 405
building CAM position profiles 406
building CAM time profiles 407
building variable arrays 407
starting offset 407
building CAM position profiles 406
building CAM time profiles 407
building variable arrays 407
C
Calculation accuracy 460
Calculation blocks 401
Build Table 405
Equation 402
Call Module block 433
Cam start and end points 248
Change Dynamics block 243
changing jog dynamics 244
Changing move dynamics 243
Pausing moves 243
Change Gain block 182
Changing jog dynamics 244
Changing move dynamics 243
Changing the gear ratio (Unchanged
direction gearing) 214
checking for an AxisLink general fault 328
checking for any fault on a specific axis 328
checking for faults on any axis 327
checking for specific faults on an axis 328
checking or waiting for an ASCII Code 424
clearing the input buffer 421
CNET 33, 753
Configuring 753
ControlNet 753
defining input bits 757
defining input floats 758
defining input group bits 760
defining inputs and outputs 755
defining local variable 761
defining output bits 763
defining output floats 764
defining output group bits 766
defining the I/O configuration 755
Deleting Bits, Floats, and Variables 768
Editing Bits, Floats, and Variables 767
enabling CNET in GML Commander
753
CNET blocks
On CNET Status 383
Reset CNET 386
Show CNET Status 385
CNET Fault 506
CNET Fault Code 546
Communication Fault 547
Incorrect Network Configuration 549
Incorrect Node Configuration 550
Media Fault 548
Plug Fault 547
CNET Status 588
Collapse option