Rockwell Automation GMLC Reference Manual - Manual (Page 179)

Publication GMLC-5.2 - November 1999
142 Working with Blocks
Swapping Blocks
Use the Swap Blocks option to swap the location and connections of two
selected blocks, even if the blocks are not connected or positioned next to
each other.
In the example that follows, the Control Settings block is swapped with
the Output block.
This is the current position of the blocks:
To swap two selected blocks in a diagram:
1. Select one of the blocks to be swapped by with your left mouse
button. It is highlighted:
2. Select the second block to be swapped by holding down the Shift key
and clicking on the second block with your left mouse button. You
should now have two selected blocks.
3. From the menu bar select Edit. The Edit menu appears.