Rockwell Automation GMLC Reference Manual - Manual (Page 390)

Publication GMLC-5.2 - November 1999
Show Input Status 353
Input – Select the dedicated axis input, the status of which (ON or OFF)
will be read.
The available selections depend upon the Controller Type selected in the
General page of the Configure Control Options dialog box and the Axis
selected, above.
The status displayed is the current physical state (ON or OFF) of the
input. The settings (Normally Open or Normally Closed) for Hard Travel
Limits and Drive Fault Input (set in the Overtravel and Servo pages of the
Configure Axis use dialog box) are ignored.
Configured
To configure this page, make entries in the following fields:
Tag Explorer – Select an input type from the tree control. The specific
inputs or input bits associated with the selected input type appear in the
Tag Window.
Note: If an input type does not appear, it has not been enabled.
Tag Window – Select the discrete input, the status of which (ON or OFF)
will be read
Note: If a specific input does not appear, it has not been enabled.
Miscellaneous
To configure this page, select a miscellaneous input from the menu.
The available inputs vary depending upon the controller type and
firmware version you are operating.
Inputs with 1394 appended to their name are available only for the IMC S
Class 1394/1394 Turbo servo controller.