Rockwell Automation 20P PowerFlex DC Drive - Frame B SCR Modules - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame B SCR Modules
What This Kit Includes
•
SCR Modules (3 for non-regenerative drives, 6 for regenerative drives)
•
Mounting screws and washers (6 for non-regenerative drives, 12 for
non-regenerative drives)
•
Gate leads (6 for non-regenerative drives, 12 for regenerative drives)
•
Thermal grease
•
Static strap
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
•
Nut driver or wrench for hex stand-offs
•
Torque wrench
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.