Rockwell Automation GMLC Reference Manual - Manual (Page 93)

Publication GMLC-5.2 - November 1999
56 Configuring Control Options
4. Make entries in the following fields:
5. Select OK. The selected options are stored as part of the current GML
Commander diagram. The dialog box closes.
Configuring the DH-485 Interface
The Data Highway (DH-485) interface enables communications
capability between motion controllers, SLC controllers, and operator
interfaces on a DH-485 communication network.
To configure the DH-485:
1. Select DH-485 in the Configure Control Options dialog box.
2. Select Communications in the field to the right of the DH-485 field.
3. Select the DH-485 tab. The DH-485 page appears.
Field Description
Controller x Select the address(es) of the controller(s) from
which you want this controller to receive
outputs.
Note:
The address of the current controller
(the one you assigned in the Address
of This Control field) is grayed out.