Rockwell Automation GMLC Reference Manual - Manual (Page 418)

Publication GMLC-5.2 - November 1999
Reset RIO 381
Tag Window
Select the discrete output that receives (On) or no longer receives (Off)
data.
Reset RIO
Use the Reset RIO block to reset the RIO option after a communications
failure.
The Reset RIO block resides on the RIO Toolbar.
The Show RIO Status block requires no parameters, and no dialog box is
associated with it.
If you enabled RIO Interface in the General and RIO pages of the
Configure Control Options dialog box, you can use the Reset RIO block
to reset the RIO option after a communications failure. This block
requires no parameters and it always has a check mark by the upper left
corner of the block to indicate that it is complete.
See Using the RIO Adapter Option chapter in this manual for information
on configuring RIO operation.