Rockwell Automation GMLC Reference Manual - Manual (Page 77)

Publication GMLC-5.2 - November 1999
40 Configuring Control Options
Defining Flex I/O
For every module selected in the Modules area of the Flex I/O page of the
Configure Control Option dialog box, there is another selection added to
the modules listed for the Flex I/O menu in the menu bar. An example is
shown here. You must continue to define the Flex I/O module types and
configuration options from this Flex I/O menu.
Important: The default module names are shown above. If you had
renamed MODULE0 to Module Stop Test in the Flex I/O tab
of the Configure Control Options dialog box,
Module_Stop_Test would replace MODULE0 at the top of
the Flex I/O module names.
To define Flex I/O:
1. Select Configure, from the menu bar. The Configure menu appears.
2. Select Flex I/O. A menu containing the names of the Flex I/O mod-
ules you’ve configured appears.
Important: Configure your Flex I/O starting with the first module
(MODULE0) in the series and continuing until all selected
modules are defined.
3. Select a module. A dialog box similar to the following appears.