Rockwell Automation GMLC Reference Manual - Manual (Page 71)

Publication GMLC-5.2 - November 1999
34 Configuring Control Options
3. In the Applications Options area, select the type of interfaces to be
used:
AxisLink Selects AxisLink to enable communications for
up to eight motion controllers on a network. An
AxisLink tab appears.
For more information, see the Configuring the
AxisLink Interface section later in this manual.
DH-485 Select this to enable DH-485 operations for
your controller. A DH-485 tab appears.
Note:
This option is not available for IMC S
Class Basic/Integrated.
For more information, see the Configuring the
DH-485 Interface section later in this chapter.
Multidrop Selects a Multidrop interface for your
controller. No tab appears.
For more information, see the Configuring the
Multidrop Interface section later in this chapter.
Field Description
Run Program
On Power-up The motion controller’s program runs
whenever power is applied.
Note: Deselect this option when developing
and debugging your diagram.
!
ATTENTION: Do not use if RIO interface is
selected and the PLC is running the program.
Field Description