Layer 2 static link aggregation configuration, Creating a layer 2 static aggregation group – H3C Technologies H3C SecPath F1000-E User Manual
Page 97
7
Meanwhile, the system with the higher system ID, being aware of the aggregation state changes on the
remote system, sets the aggregation state of local member ports the same as their peer ports.
NOTE:
•
To ensure stable aggregation state and service continuity, avoid changing port attributes or class-two
configurations on any member port.
•
In a dynamic aggregation group, when the aggregation state of a local port changes, the aggregation
state of the peer port also changes accordingly.
•
A port that joins a dynamic aggregation group after the Selected port limit has been reached will be
placed in the Selected state if it is more eligible for being selected than a current member port.
Layer 2 Static Link Aggregation Configuration
Layer 2 Static Link Aggregation Configuration Task List
Complete the following tasks to configure Layer 2 static link aggregation:
Task Remarks
Creating a Layer 2 Static Aggregation Group
Assign one interface or multiple interfaces to the
aggregation group
Required
NOTE:
z
You can assign only Layer 2 interfaces to a Layer
2 aggregation group.
z
The two steps are simultaneously completed on
the Setup tab.
Creating a Layer 2 Static Aggregation Group
Select Device Management > Bridge Aggregation from the navigation tree to enter the page as
shown in
.