Verification – H3C Technologies H3C SecPath F1000-E User Manual
Page 772
26
•
Select Management from the Zone drop-down list. (Select a security zone according to your
network configuration.)
•
Type the tunnel source IP address 11.1.1.3.
•
Type the tunnel destination IP address 11.1.1.1.
•
Type the GRE key 2.
•
Click Apply.
# Configure a static route from Device C through interface Tunnel 0 to the headquarters node.
•
Select Network > Routing Management > Static Routing from the navigation tree and
then click Add to perform the configurations shown in
.
Figure 46 Add a static route from Device C through interface Tunnel 0 to the headquarters node
•
Type 172.17.17.0 as the destination IP address.
•
Select mask 255.255.255.0.
•
Select Tunnel0 as the outbound interface.
•
Click Apply.
Verification
# On Host B, specify Device C as the default gateway. Ping Host A from Host B. The ping operation
succeeds.
On Device A, select VPN > GRE > P2MP from the navigation tree and then click the Tunnel List tab.
You can see information about the P2MP GRE tunnels established on Device A, as shown in
.
Figure 47 Verify the configuration result on Device A (1)