Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 117
27
Figure 30 Create a Layer 2 dynamic aggregation group on Device B
Layer 3 Static Link Aggregation Configuration Example
Network requirements
As shown in
:
•
Device A and Device B are connected by their Layer 3 Ethernet interfaces GigabitEthernet 1/1
through GigabitEthernet 1/2.
•
Configure a Layer 3 static aggregation group on Device A and Device B respectively to enable
communication between both ends.
Figure 31 Network diagram for Layer 3 static link aggregation
Configuration procedure
Step1
On Device A, create a Layer 3 static aggregation group and assign interfaces to the aggregation group,
.
•
Select Device Management > Route Aggregation from the navigation tree.
•
Type the aggregation group ID as 1.
•
Select the Static option.
•
Select the interfaces GigabitEthernet 1/1 and GigabitEthernet 1/2.
•
Click Apply.