Configuration guidelines, Figure 12 – H3C Technologies H3C SecPath F1000-E User Manual
Page 583
5
Figure 12 Configure virtual reassembly
•
Select Trust for Security Zone.
•
Select the Enable Virtual Fragment Reassembly check box.
•
Click Apply.
After the above configuration, if receiving disordered fragments from security zone Trust, Device A will
check and reassemble them.
Configuration Guidelines
1.
The virtual fragment reassembly feature only applies to packets incoming to a security zone.
2.
The virtual fragment reassembly feature does not support load sharing, that is, the fragments of an
IP datagram cannot arrive through different security zones.
This manual is related to the following products: