Configuration considerations, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 282
4
Figure 3 Network diagram for static route configuration
Configuration considerations
1.
On Device A, configure a static route to Device B.
2.
On Device B, configure two static routes to Device A and Device C, respectively.
3.
On Device C, configure a static route to Device B.
Configuration procedure
Step1
Configure IP addresses of hosts and gateways.
As shown in
, configure IP addresses of the hosts, and configure the default gateways of Host A,
Host B and Host C as 1.1.2.3, 1.1.6.1 and 1.1.3.1, respectively. The configuration procedure is omitted.
Step2
Configure IP address of the interfaces and security zones (omitted).
Step3
Configure static routes.
# Configure a static route on Device A.
•
Select Network > Routing Management > Static Routing from the navigation tree of
Device A and click Add to perform the following configurations as shown in
.
Figure 4 Configure a static route on Device A
•
Type 0.0.0.0 as the destination IP address.