H3C Technologies H3C SecPath F1000-E User Manual
Page 764
18
•
Select Tunnel0 as the outbound interface.
•
Click Apply.
Step3
Configure Device C
# Configure an IPv4 address for each interface and assign the interfaces to security zones (omitted).
# Create a GRE over IPv4 tunnel interface, with the tunnel interface number being 0.
•
Select VPN > GRE > GRE from the navigation tree and then click Add to perform the
configurations shown in
.
Figure 34 Add a GRE over IPv4 tunnel interface (Tunnel 0)
•
Type 0 in the Tunnel Interface text box.
•
Type IP address/mask 172.168.1.3/24.
•
Select Management from the Zone drop-down list. (Select a security zone according to your
network configuration.)
•
Type the tunnel source IP address 11.1.1.3.
•
Type the tunnel destination IP address 11.1.1.1.
•
Click Apply.
# Create a GRE over IPv4 tunnel interface, with the tunnel interface number being 1.
•
Select VPN > GRE > GRE from the navigation tree and then click Add to perform the
configurations shown in
.