Rip configuration example, Network requirements – H3C Technologies H3C SecPath F1000-E User Manual
Page 292
7
Item Description
Work State
Set whether to allow the receiving/sending of RIP packets on the
interface.
•
On: Allows the receiving/sending of RIP packets on the
interface.
•
Off: Disallows the receiving/sending of RIP packets on the
interface.
Version
Specify a RIP version for the interface.
•
Default: Indicates the interface can send RIPv1 broadcasts and
can receive RIPv1 broadcast and unicast packets, and RIPv2
broadcast, multicast, and unicast packets.
•
RIPv1: Indicates the interface can send RIPv1 broadcasts, and
can receive RIPv1 broadcasts and RIPv1 unicasts.
•
RIPv2: Indicates the interface can send RIPv2 multicasts and
can receive RIPv2 unicasts, broadcasts and multicasts.
•
RIPv2 broadcast: Indicates the interface can send RIPv2
broadcasts and can receive RIPv1 unicasts, and broadcasts, and
RIPv2 broadcasts, multicasts and unicasts.
Authentication Mode
Key String
Key ID
Set the authentication mode and parameters for authenticating RIP
packets on a RIPv2 interface.
•
If the Authentication Mode is null, the interface does not
authenticate RIP packets, and the Key String and Key ID are
not required.
•
If Simple is specified for Authentication Mode, the
interface authenticates RIP packets using simple text key. You
need to configure a Key String in simple text.
•
If MD5 RFC2453 is specified for Authentication Mode, the
interface adopts the MD5 authentication mode, and the
authentication packet is in the format defined in RFC 2453. You
need to configure a Key String in MD5 cipher text.
•
If MD5 RFC2082 is specified for Authentication Mode,
the interface adopts the MD5 authentication mode, and the
authentication packet is in the format defined in RFC 2082.
Then, you need to configure a Key String in MD5 cipher text
and a Key ID.
IMPORTANT:
If Default or RIPv1 is specified as the RIP version, the
authentication information you have configured does not take
effect.
.
RIP Configuration Example
Network requirements
As shown in
, enable RIP on all interfaces on Device A and Device B.