H3C Technologies H3C SecPath F1000-E - Manual (Page 315)

20
Figure 22 OSPF area configuration page
Table 3 describes the OSPF area configuration items.
Table 3 OSPF area configuration items
Item Description
Area ID Type an area ID.
Area Type
Select an area type, including Normal, Stub, and NSSA.
Caution:
The type of a backbone area (with area ID 0) can only be configured as
Normal.
Enable all interfaces Set whether to enable OSPF on all the interfaces.
Network
Address
Network
Items
Network Mask
Specify a network segment in the area, so as to enable OSPF on the interface
attached to the specified network segment.
After specifying a correct Network Address and Network Mask, click
Add Network to add the specified network segment to the area. You can
select one or more network segments from Network Items, and then click
Delete Network to delete them.
This option is not available if the Enable all interfaces check box is selected;
the network address cannot be configured as a loopback or multicast address;
the network segment in the Network Items cannot overlap any existing
network segment in the area.