H3C Technologies H3C SecPath F1000-E - Manual (Page 586)

3
Figure 15 Network diagram for ASPF configuration
Configuration procedure
Step1 Configure zone 1 and zone 2, and specify security zones for the interfaces. (omitted)
Step2 Configure an ASPF policy.
# Create an ASPF policy.
• Select Firewall > Session Table > Advanced from the navigation tree, select the ASPF tab,
and then click Add to perform configurations shown in
Figure 16 .
Figure 16 Configure ASPF policy
• Select zone 1 from the Source Zone drop-down box.
• Select zone 2 from the Dest Zone drop-down box.
• Select the Discard ICMP error packets check box.
• Click Apply.