Ethernet link aggregation configuration examples, Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 111
21
Ethernet Link Aggregation Configuration Examples
Layer 2 Static Link Aggregation Configuration Example
Network requirements
As shown in
:
•
Device A and Device B are connected through their respective Layer 2 Ethernet interfaces
GigabitEthernet 1/1 through GigabitEthernet 1/2.
•
Configure a Layer 2 static aggregation group on Device A and Device B respectively to enable
communication between VLAN 10 at both ends of the aggregate link and between VLAN 20 at
both ends of the aggregate link.
Figure 23 Network diagram for Layer 2 static link aggregation
Configuration procedure
Step1
On Device A, create a Layer 2 static aggregation group and assign interfaces to the aggregation group,
.
•
Select Device Management > Bridge Aggregation from the navigation tree.
•
Type the aggregation group ID as 1.
•
Select the Static option.
•
Select the interfaces GigabitEthernet 1/1 and GigabitEthernet 1/2.
•
Click Apply.