H3C Technologies H3C SecPath F1000-E - Manual (Page 126)

2
Figure 1 Zone classification
Zone_DMZ
Zone_RND
Configuring a Zone
Configuration Task List
Perform the tasks in Table 1 to configure a zone.
Table 1 Zone configuration task list
Task Remarks
Select the virtual device to which the specified zone
belongs
Optional
Select Device Management > Virtual Device >
Device Selection from the navigation tree to enter
the virtual device selection page. For detailed
configurations, refer to Virtual Device Configuration.
By default, a virtual root device is used.
Creating a Zone
Optional
By default, the following zones are available on the
virtual root device: Management, Local, Trust, DMZ
and Untrust.
Configuring a Zone Member
Required
Add specified subnet address source, interfaces,
Layer 2 Ethernet interface + VLAN to the created
zone, and the interfaces that can be added and the
VLANs must be on the same virtual device with the
zone.